New member (well, not really)

[bboypuertoroc]

I've been on here for a while, but never introduced myself (or posted, for that matter).

My name is Tony. Currently I drive an Evo IX GSR. Got a pretty basic build right now... FPRed, cams, valve springs/retainers, ported this, intercooler that, etc. Currently I'm being tuned by Chris (Mellon).

I'm employed by Uncle Sam and stationed in the Aloha State.

I'm planning on upgrading some existing parts to Buschur pieces (mainly my FMIC and exhaust manifold), getting my intake manifold and throttle body ported, and also eventually getting the stage 3 head+2.0 block. Might even upgrade my turbo down the road to an HTA35R (or slightly bigger).

Well then, back to lurking. Hell, I might even post somewhere now.

EDIT: Holy shitballs I've been a member on here for a while. I forgot I joined back when I had my 2G (running).

[bboypuertoroc]

I guess I'll post up my mod list so it can be thouroughly dissected...

Engine:
- TurboXS RFL Ti cat back
- TurboXS RFL downpipe
- TurboXS RFL test pipe
- EPM O2 dump
- Hallman manual boost controller
- Buschur Racing MAF pipe and filter
- Walbro 255 fuel pump
- ETS 3.5" wide-tank intercooler
- ETS short-route upper intercooler pipe
- ETS lower intercooler pipe
- ETS mini battery kit
- PTE 1000cc injectors
- Forced Performance Evo Red turbo
- PPI ported/coated exhaust manifold
- Kelford 272 cams
- GSC Beehive valve springs
- GSC titanium retainers
- ARP head studs
- TiAL BOV
- Buschur Racing aluminum shift linkage bushings
- ACT HDSS clutch
- Gruppe-S 10.5lb flywheel
- Mellon tune

Interior:
- Defi BF Series Amber Boost, Water Temp, Oil Temp gauges
- Defi Control Unit II
- Innovate LC-1 wideband
- Innovate XD 16 gauge
- Gruppe-S gauge panel
- Mitsubishi radio relocation kit
- B+M short shifter
- Speed Source shifter base bushings
- Tactrix cable

Exterior:
- JDM Evo IX rear bumper
- Rexpeed Carbon fiber lip
- Rexpeed Carbon Fiber JDM rear bumper extensions
- Rexpeed Carbon Fiber JDM rear bumper heat shield
- MR Vortex Generator
- MR Gurney Flap
- JDM VIII MR taillights
- JDM turn signals
- Blacked-out headlights
- 6000k HIDs
- Debadged
- S2000 Antenna

Suspension:
- Tanabe GF210 springs
- Progress 25mm rear sway bar
- Whiteline Roll Center Adjustment kit
- Falken Azenis RT-615s
- Hawk HPS pads
- Stoptech slotted rotors
- Motul RBF 600 brake fluid

In Car Electronics:
- Kenwood Receiver

[Poondogggs]

You said you had a pretty basic build? lol.

[AcePitcher11]

Any pics? What kind of power are you making on the DLL? Have you had it to the track at all?

[blackout]

Thats a pretty big list man. lol Post up some pics when you get a chance.

[yellowevo42]

Welcome!!! PICS!!!!!!!!!!!!!!!

[bboypuertoroc]

You said you had a pretty basic build? lol.

LMAO... looking at what a lot of Evos are running these days I'd say I'm pretty basic LOL.

[bboypuertoroc]

Any pics? What kind of power are you making on the DLL? Have you had it to the track at all?

Here's one of my recent DLL logs (this is untuned at 30psi on pump):



I made a hundred dollar bet with a friend that it would break 400 on a Dynojet as it sat (which it did) untuned. It hit like 410 and 350-360awtq (don't have the dyno on me right now). Also hit full boost at ~4100rpm... gotta love the Red and Mellon's work!!! The run was started way before where my tune actually starts (run starts at like 1500rpm or some shit which caused knock the entire run.

I had it to the track when it was still stock turbo and ran a 12.3@114. Track was shitty though... timing was off (I was passing through the trap at 7800-8000rpm in 4th) which is more than 114mph. Also, there was NO track prep whatsoever.

On with the pics now:









Old auto-x pic:



And my latest 1/4 video from my club's trip to Maui Raceway Park (we have no track on this island):

http://videos.streetfire.net/video/O...-at_187008.htm

[yellowevo42]

Not bad at all..

[bboypuertoroc]

It's funny... if you watch the vid, you can see the C63 AMG that I whooped up on in my rearview.